This is an essential accessory for use in Vacuum Chucking applications. It allows you to center a partially turned bowl on a vacuum chuck without removing the bowl from your lathe chuck or face plate. Simply screw this into your chuck or face plate and insert into your tailstock. The threaded area is made of aluminum then permanently attached to a hardened and ground steel Morse Taper Arbor. This is designed for accurately positioning only and is not for use under power.
1" - 8 TPI has a #2 Morse Taper
1" - 12 TPI has a #2 Morse Taper
1-1/8" TPI has a #2 Morse Taper
1-1/4" - 8 TPI has a #2 Morse Taper
1-1/2" - 8 TPI has a #2 Morse Taper
M30 x 3.5mm has a #2 Morse Taper
M33 x 3.5mm has a #3 Morse Taper
Other Sizes Available on request.
*** NOT FOR USE IN SPINDLES ***